PRTG Manual: SNMP MIB Walker
The SNMP MIB Walker is simple tool to help test and trouble shoot SNMP data on any SNMP enabled device. This is accomplished by the following steps:
1.Select an IP device from the current discovery results (or manually entering an IP Address: field)
2.Select a SNMP Credential to use when querying the device.
3.Select a MIB OID from the MIB Tree on the left (the selected value will show in the OID: field)
3.NOTE: You may also enter any known OID in the OID field to test whether the device has any data under that OID value.
4.Use one of the following actions:
4.Get-Next : Perform a SNMP Get-Next request given the current OID value.
4.Get-Table: Perform successive SNMP Get-Next requests to query all values under the selected OID root.
5.The SNMP query results will be shown in the right table.
NOTE: This SNMP MIB walker is not yet a full featured SNMP MIB tool. It currently supports operations that are mainly focused on troubleshooting SNMP devices so as to gather the necessary SNMP values to ensure UVexplorer is providing its greatest level of functionality.
