There are a lot of Lexmark printer errors out there. Way too many, right?

Quick fix

The error 200 is a very common error message with Lexmark printers. All 200.xx errors indicate a paper jam at the front of your Lexmark printer. Sometimes, the error message also says “Paper Jam” or “Paper jammed under the toner cartridge” or “Paper is jammed in the front of the printer”.

To get rid of error 200, you need to remove any paper stuck in the printer by following these easy steps: Open the upper front cover of your Lexmark printer and remove the toner cartridge. Now carefully remove the paper from the inside of the printer. Then reinstall the toner and close the front cover.

Quick fix

If your Lexmark printer displays a 900 Firmware Error, you are facing a communication issue. First of all, determine whether the error only occurs when the printer is receiving information from your network or from a computer. If this is the case, reach out to Lexmark’s technical support, as this indicates a problem with the software.

Does error 900 occur while your Lexmark printer is not connected to your network or your computer? In this case, the error could be caused by a problem with the hardware or by a connection problem. To solve the issue, turn off the printer and disconnect all cables except the power cord. Turn the printer back on and see if the error still occurs. Also download and update the latest Lexmark firmware. If the 900 error returns, your Lexmark printer may need service.

Best solution:

• https://www.printerfixes.com/how-to-fix-900-firmware-error-lexmark-printer/

Quick fix

The error message “Load MP Feeder” on a Lexmark printer indicates that you need to load paper into the front-loading multipurpose feeder (MP Feeder). There are several solutions to the problem.

If you try to feed from the MP feeder, make sure that the tray is loaded with paper. If the error message persists despite the feeder being loaded with paper, it is most definitely caused by a loose sensor flag or a bad sensor. Check if the sensor flag is hanging down and resting on the paper. If it is loose or missing, you need to put it back into place or renew it in order to get rid of the “Load MP Feeder” error message.

If you do not want your Lexmark printer to feed from the MP feeder, but you still receive the error message, change the default paper source in the settings, then try again.

Quick fix

Lexmark printer error 241.06 is a paper jam issue. The error commonly occurs with older Lexmark printers that are equipped with older types of pick tires, causing a sensor problem during the print job. The sensors are noticing a paper jam, even though there is no paper stuck in the tray.

To solve the problem, pull the paper tray out from the drawer and look for the pick tires. If the pick tires are gray or tan, your Lexmark printer uses the old types. To get rid of the 241.06 error, replace the pick tires with the newer types, which are green in color.

If your printer already has new pick tires, and you are still facing error message 241.06, reach out to the Lexmark technical support, as this may indicate an additional hardware problem.

Best solution:

• https://support.lexmark.com/en_us.html